Adjusting the worktop
You can move the worktop forward or backward by
25 mm in order to align the machine with other kitchen units.
Simply unscrew the two rear retaining screws, move the top
to the required position and then retighten the screws.
Fitting under a counterIN26
(kitchen worktop or sink)
By removing the machineOs worktop, you can install it under
a close fitting sink unit or a pre-existing top, providing the570 - 600
dimensions of the recess correspond to those shown in the
picture.
Proceed as follows:
- Remo ve the machineOs worktop by unscrewing the 820
two rear retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.600
Insert the machine after adjusting height and levelling with
the adjustable feet.When inserting the machine, ensure that
the water inlet and drain hoses are not kinked or squashed.IN05
Technical specifications
DimensionsWidth60 cm
Height with worktop85 cm
Height without worktop82 cm
Max depth55.5 cm
Max depth with open door115,2cm
Electrical connectionVoltage220/240 V - 50 Hz
Motor rating during wash200 W
Power of heating element2100 W
Overall power2300 W
W ater supply pressureMinimum 50 kPa (0.5 bar)
Maximum 800 kPa (8 bar)
Capacity12 place settings
7 |
ACEC
